ONEIC.US

STM32F407VGT6alternatives & cross reference

1 Chinese-brand replacement candidate for STM32F407VGT6 (STMicroelectronics) in MCU — each labeled with its verification level and parameter differences. Shenzhen sourcing, quote in 24 hours.

GD32F407VGT6

GigaDevice · MCU

VerifiedFAE reviewed
Pin-to-pinPin-compatibleUpdated 2026-10-30Vendor document
ParameterSTM32F407VGT6GD32F407VGT6Engineering note
Package and pin sequenceSTM32F407VGT6: LQFP100, 14 x 14 mmGD32F407VGT6: LQFP100, 14 x 14 mm, green industrialThe exact order codes are both LQFP100. Table-based comparison found the same physical pin names on 1 through 100 except ST VCAP_1/VCAP_2 at pins 49/73, which the GD table marks NC.
External VCAP pinsVCAP_1 on pin 49 and VCAP_2 on pin 73Pins 49 and 73 are marked NCRemove or independently assess ST-oriented VCAP capacitors and regulator/reset circuitry. The physical land positions align, but the electrical function of these pins is not identical.
Flash organization1024 KB contiguous code Flash in the VG order code1024 KB total: 512 KB code area plus 512 KB data areaTotal Flash capacity matches, but the target's code/data partition differs from the source. Firmware-linking, code execution above 512 KB, boot behavior and data-flash use require target-specific review.
Operating supply voltage1.8 V to 3.6 V2.6 V to 3.6 VThe target minimum supply is 0.8 V higher. Designs operating below 2.6 V are not eligible for this replacement.
Peripheral identifiers and softwareSTM32 TIMx, SPIx, I2Cx, USARTx register and firmware ecosystemGD32 TIMERx, SPIx, I2Cx, USARTx register and firmware ecosystemThe package and SRAM capacity correspond, but peripheral numbering, registers, clock setup, USB/Ethernet behavior, drivers and tool support differ.

FAE documentary review accepted for the exact STM32F407VGT6 and GD32F407VGT6 order codes. Both are 1 MB Flash-class, 192 KB SRAM, 82-GPIO, 168 MHz LQFP100 Cortex-M4 MCUs rated -40 C to +85 C. GD organizes the 1 MB as 512 KB code plus 512 KB data area, so code execution and Flash addressing need target-specific review. The complete pin table matches except ST VCAP_1/VCAP_2 at pins 49/73, where GD marks NC, and the target minimum supply rises to 2.6 V. Document review only; not bench, temperature-cycle, EMC, reliability or production qualified.

View on ONEICShenzhen sourcing · price & lead time by RFQ

Related cross-references

Disclaimer

Cross-reference suggestions for STM32F407VGT6 are provided for engineering convenience and are based on published specifications, vendor documents, or parametric analysis as labeled on each entry. They do not constitute an endorsement by, or an affiliation with, STMicroelectronics, and they are not a guarantee of suitability for any specific application. Always validate alternatives against both manufacturers' current datasheets and your own qualification process before production use.